Here you have one BSA brake pedal return spring, produced as a direct replacement for the original but made of solid stainless steel.

Part number: 67-7032

Material: Stainless steel

Finish: Polished - Tumbler

This spring was fitted on all A group plunger models fitted with Crinkle Hub:

This spring may fit other models but please check your part numbers.

These springs are an improvement for a number of reasons! 

• Structural integrity - They will do their job for longer! Stainless is stronger than the original steel and even more so when compared to Chromium Vanadium springs.
• Resistance to corrosion - no more rusty springs!

• Aesthetic Appeal - let face it, they look better!
• Environment purity - With no rust flakes falling off, these springs will also keep the area's around them cleaner.
• Easy to Clean - had them fitted for a while? a quick clean off and they look like new all over again!

Each of the springs has had at least 3 hours in our tumbler, this gives them a good finish, please see photos! The finish is not "chrome" or "show finish".